reduction ratio造句
例句与造句
- High reduction ratio during primary and secondary crushing stage
初段，二段等各段破碎均有大破碎比。 - Unbalance reduction ratio
不平衡量减少率 - Gear reduction ratio
齿轮减速比 - Total reduction ratio
总减速比 - Gross reduction ratio
总破碎比 - It's difficult to find reduction ratio in a sentence. 用reduction ratio造句挺难的
- Effects of gaseous pollutants reduction ratio on energy eco - efficiency of coal - fired plant in china
污染物的脱除率对燃煤电站生态效率的影响 - Effect of cold rolled reduction ratio on deep - drawing properties of low carbon al - killed and cold rolled steel sheet
冷轧压下率对低碳铝镇静钢冷轧板深冲性能的影响 - Microfilm technics , microfilming of engineering drawings ; reduction ratios for recording on film 35 mm and reenlargement ratio
缩微照相技术.技术图纸缩微照相.在35mm缩微胶片上录 - The optimal extrusion parameters are as following : extrusion temperature is 375 - 400 ? , the reduction ratio is 25 : 1
该合金的最佳挤压工艺参数为，挤压温度为375 - 400 ，挤压比为25 : 1 。 - 2 . the room temperature tensile strength of alloy made by mlsd relate to the extrusion temperature and the extrusion reduction ratio , with high temperature and reduction ratio , the tensile strength becomes low
二、多层喷射沉积过共晶a1 - si合金的室温强度与挤压温度和挤压比有关，挤压温度越高，合金的强度会降低。 - Then paper introduces a method by which the engine size and the speed reduction ratio from the engine to drive wheels based on the cruising mode ( one of the two basic modes for an electrically peaking hybrid vehicle ' s operation )
而后重点针对电力峰值型并联混合动力电动汽车动力的两种操作模式介绍了一种基于恒定高速行驶模式的，用来确定发动机大小以及发动机与驱动轮之间传动比的方法。 - Its reliability has been tested though examining . the influence laws of mould structure , including wiper die and the style , size and installed position of mandrel , have been studied . combined with the theoretical analysis of perfect pure bending , the tendency of relative bending radius r / d and relative wall thickness t / d to one of the major quality target - the maximum wall thickness reduction ratio is also studied
通过数值模拟研究获得了包括防皱块和芯棒形式、尺寸和安装位置在内的模具结构对制件成形质量的影响规律；结合对理想纯弯曲的理论分析，研究获得了相对弯曲半径r / d 、相对壁厚t / d对制件主要质量指标之一的最大壁厚减薄率的影响趋势和大小。 - Result of numerical simulation shows that the grads of continuous phase " s velocities decreases with the presence of microbubble of which the diameter is 100 / / w , the profiles of air volume fraction in the boundary layers is similar to triangle or echelon , affected by interaction among the particle , there is a saturated air fraction , within the scope of saturated air fraction , increasing the air injection ratio can accrete the friction reduction ratio , under the condition of same air injection ratio , the free - steam velocity is larger , the effect of friction reduction is worse
计算结果表明，直径为100 m的微气泡能减小近壁面连续相的速度梯度；微气泡在边界层中的浓度分布近似为三角形或梯形分布；受粒子间相互作用的影响，存在一饱和浓度；减阻率随喷气量的增大而增大，直至饱和喷气量，此后，增大喷气量，壁面摩擦阻力变化不大；相同喷气量下，来流速度越大，减阻率越低。